Wind Turbine Technology

From energypedia
Revision as of 14:45, 19 February 2014 by ***** (***** | *****)
Maintenance: Revision needed
This article needs to be revised. Please rewrite the article according to the specifications below. Only remove this maintenance box after a thorough revision of this article. See the discussion page for more details or start a discussion there.

In particular the following aspects and passages have been specified to be in need for a revision:
(PLEASE HELP TO FILL THIS ARTICLE WITH MORE INFORMATION.).

Introduction

A wind turbine is a device that converts kinetic energy from the wind into electrical power[1].The role of wind turbines is to extract energy from wind and convert it to electrical energy. This extraction is subjected to certain limitations represented by Betz’s limit which is the maximum energy possible to convert kinetic energy into mechanical energy without any losses[2].

Wind Turbine Control Concepts

An ideal wind turbine has a maximum power coefficient of 16/27.The theoretical limit cannot be exceeded and this caused by the aerodynamic losses due to conversion of angular momentum,tip and drag[3].

Power coefficients of different rotors of different designs


Turbine Power output can can be expressed as follows:

����P= ½ * ρ* A * v³* Cp

where ρ is density of air, A is the area swept by rotor and v is the velocity of wind.


The extracted power is then converted into electrical power and is defined as:

P=VI

where P is the electrical power in watt

V is the voltage in V

I is the current in A

Aerodynamics

Aerodynamics of a wind turbine blade

[4]

Stall

Wind turbine blade aerodynamics - stall control

[5]

Stall Control:

Passive Stall

Power of the wind turbine is limited by the aerodynamic characteristics of the turbine.

Active Stall

Power of the wind turbine is limited additionally by decreasing the pitch angle (increasing the inflow angle ).


Pitch

Aerodynamics at a wind turbine blade during control through pitching

[6]

Pitch Control:

  • Power of the wind turbine is limited by increasing the pitch angle (decreasing the inflow angle α)


Wind Turbine Operation

Operation of Fix Speed Wind Turbine (Passive Stall)

  • Start up (with open breaker) if wind speed > cut-in wind speed
  • Close breaker
  • Operation at constant blade angle over the whole wind speed range
  • In case of large wind speeds: Power limited by aerodynamic profile.


Operation of Variable Speed Wind-Turbines

Start up (with open breaker) if wind speed > cut-in wi

Typical power curves of wind turbines.jpg

nd speed
• Close breaker



• Below rated wind-speed
– Maximum power coefficient (Max. Power Tracking)



– Evt: Speed Limitation
• Above rated wind-speed:
– P=Pr
ated (Limited by power electronics converter)
– Pitching

• Advantages of variable speed operation:
– Lower cut-in wind speeds
– Higher efficiency, especially at low wind speeds
– Lower power variations (compared to fixed speed turbines)
• Disadvantage: More expensive!


[7]

Generator Concepts

Overview Wind generator concepts.jpg

[8]

Fixed Speed Induction Generator

Fixed speed induction generator.jpg

[9]

Only fix speed operation possible (stall control required)
• Reactive power compensation required
• No reactive power control capability. Additional devices required:
– TSCs (Thyristor switched capacitors)
– STATCOMs
• Risk of dynamic voltage collapse
GTZ Expert Workshop 2010: Grid and System Integration of Wind Energy, 22/23.11.2010, Berlin/Germany
y g p
– > Typically, wind generators based on induction generators are asked to
disconnect in case of voltage dips

Induction Generator with Variable Rotor Resistance

Induction Generator with Variable Rotor Resistance.jpg

[10]

Simple concept for variable speed operation.
• Reactive power compensation required.
• No reactive power control capability. Additional devices required:
– TSCs (Thyristor switched capacitors)
– STATCOMs
• Limited LVRT capability. Dynamic voltage collapse problems have to
GTZ Expert Workshop 2010: Grid and System Integration of Wind Energy, 22/23.11.2010, Berlin/Germany
be mitigated by:
– Fast increase of rotor resistance during faults
– Additional reactive power compensation devices (typically TSCs)


Doubly-Fed Induction Generator

Doubly-fed induction generator.jpg

[11]

Doubly fed induction generatorf Power flow over- and subsyncronous speed.jpg

[12]

Generator with Fully Rated Converter

Generator with Fully Rated Converter Kopie.jpg

[13]

Generator with Fully Rated Converter and Direct Drive

Generator with Fully Rated Converter and direct drive.jpg

[14]

Directly Coupled Synchronous Generator with Variable Gear Box

Directly Coupled Synchronous Generator with Variable Gear Box.jpg

[15]

References

  1. http://en.wikipedia.org/wiki/Wind_turbine
  2. J. F. Manwell, J. G. McGowan and A. L. Rogers. WIND ENERGY; Theory, Design and Application. United Kingdom : John Wiley & Sons Ltd, 2009
  3. DESIGN AND POWER CHARACTERIZATION OF A SMALL WIND TURBINE MODEL IN PARTIAL LOAD REGION by Abdulkarim Abdulrazek
  4. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[1]]
  5. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[2]]
  6. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[3]]
  7. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[4]]
  8. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[5]]
  9. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[6]]
  10. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[7]]
  11. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[8]]
  12. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[9]]
  13. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[10]]
  14. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[11]]
  15. Weigel S., Poeller M. (2010) Wind Turbine Generators (WTGs) Physical Principals and Generator Concepts, Presentation prepared by DigSILENT GmbH for the Wind Energy and Development Dialogue 2010, retrieved 27.8.2011 [[12]]

Portal:Wind